Olympus – Camedia C-360 Zoom – Quick Start

Category: Digital Camera, Film Camera, and Vintage Camera User Guides and Manuals

Download user manual for Olympus – Camedia C-360 Zoom – Quick Start 
Preview: Below is a preview of the manual as extracted from the PDF file


QuickStart Guide
PREPARING THE CAMERA FOR USE
Before you begin using your Olympus Digital camera…
a. Loading the battery
Note: The batteries and xD-Picture card
compartments are accessed by opening the
respective compartment covers.
• Close the lens barrier.
• Slide the battery compartment cover to the direction of the
arrow, and lift open the cover as shown in the illustration.
• Insert the batteries into the compartment.
• Close the battery compartment cover so that it pushes the
battery in and slide the cover while pressing the mark.
Note: If the battery compartment cover is hard to
close, do not force it. Press on the cover firmly
to close the cover, and then slide it into position.
• To remove the batteries, make sure that the monitor and the
lamps at the side of the viewfinder are off.
b. Inserting the xD-Picture Card
The xD-Picture Card is where the camera stores your pictures
and is available in a variety of memory capacities. The pictures
you take with the camera remain on the xD-Picture Card even
when the camera is turned off and/or the batteries are removed.
• Open the card cover.
• Face the card the correct way and insert it into the card slot.
• Insert the xD-Picture Card into the spring-loaded card slot as
shown in the illustration. Push the card fully into the slot. The card
will lock into place when fully inserted.
• To remove, push the card all the way in to unlock it, then let it return
slowly.
• Close the card cover securely.
Confirm you have installed the battery and xD-Picture Card
properly by pressing . The “NO PICTURE” message should be displayed in the monitor. Turn
the camera off by pressing again.
c. Attaching the strap (OPTIONAL)
Attach the strap as illustrated to make the camera easier to
handle.
Lens Monitor
Contact area
TURNING ON THE CAMERA
All you need to do is slide the lens barrier open or closed to turn the camera ON or OFF.
a. Turning the camera ON (SHOOTING MODE)
• Slide the lens barrier open fully until it clicks. The lens extends and the subject is displayed on the monitor.
• To turn the camera off, slide the lens barrier until you feel the first click. Wait until the lens is fully retracted, then
close the lens barrier all the way.
To maximize battery life, the built-in power-saver operates, and the camera enters sleep mode after approximately three (3)
minutes of non-use.
b. Setting the Date and Time (OPTIONAL)
Set the date and time before using the camera for the first time. This affects the way image file names are
created, and will conveniently include this information with each picture.
• With the front lens barrier closed, press once. The monitor will turn on with “NO PICTURE” displayed in the
monitor. The date and time can also be set when the camera is in the shooting mode.
• Press to display the top menu.
• Press to select MODE MENU.
• Press to select SETUP, and then press .
• Press to select , and then press .
• Use to select the date format.
• Adjust the date and time in the appropriate fields by using to select the field, and to set the proper value.
Repeat this step until all date/time fields have been set.
Note: Time is entered using the 24-hour format.
• Press twice to set the date and time and exit the menu.
c. Camera Diagram and Controls
Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.
Power on Power off
TIP
A/V OUT (MONO) jack
Self-timer control lamp Flash
DC-IN jack
DC-IN jack
cover
Lens barrier Lens
USB connector
Card cover
Strap eyelet
Battery compartment
cover
Connector cover
Microphone
UNPACKING THE BOX CONTENTS
Gather your Digital camera and the parts as shown in the illustration. You’ll need these to complete the steps for the camera
set-up procedures that follow. The items, such as batteries, supplied with the camera may differ depending on the area you
purchase the product.
START HERE
It is strongly recommended that you follow these step-by-step
numbered instructions to set up and quickly begin using your
new Digital camera.
OLYMPUS AMERICA INC.
Two Corporate Center Drive, Melville,
NY 11747-3157, U.S.A.
http://www.olympusamerica.com/support
For more detailed instructions on advanced features, please refer to
the printed Basic Manual included in your package, or the Reference
Manual on the CD-ROM.
Camera Settings in Shooting Mode as shown in Monitor
Camera Settings in Playback Mode as shown in Monitor
Note: Depending on the camera settings, not all indicators will be displayed.
Tripod socket
Viewfinder
Green lamp
Orange lamp
Playback button
(QUICK VIEW )
Monitor
OK/Menu button
Shutter button Zoom lever
Arrow pad ( )
Macro button
Self-timer button
Flash mode button Shooting mode button
Battery check
Green lamp
Flash stand-by
Flash mode
Macro mode
Memory gauge
Shooting mode
Exposure compensation
Self-timer
White balance
Metering
Record mode Number of storable
still pictures
AF target mark
Sequential shooting
Resolution
Sound record
Battery check
Print reservation
Number of prints
Protect
Record mode
Resolution
Exposure compensation
White balance
Date and time
File number
(still picture)
Sound record
Olympus Europa GmbH
Wendenstrasse 14-18,
20097 Hamburg, Germany
http://www.olympus-europa.com
The following items are also included in the Digital camera package: Basic Manual, AV cable, warranty card, registration card (not provided
in some areas), and safety precautions booklet.
Digital camera Strap AA (R6) alkaline batteries (2) CAMEDIA Master
CD-ROM
USB cable (gray color) xD-Picture Card
http://www.olympus.com/
D-575ZOOM / C-360ZOOM / X-350
1AG6P1P1978– VT747201
Printed in Japan
qsge_pquick.fm 1 ページ 2003年12月15日 月曜日 午前10時37分
VIEWING AND
ERASING PICTURES
With a Digital camera, you can easily view the photos you
want—and delete the ones you don’t.
a. Viewing Pictures
There are two ways to access the Playback mode:
• If the camera is OFF and the lens barrier closed, press
once.
OR
• If the camera is in the shooting mode with the lens barrier
fully open, press (QUICK VIEW).
The last picture taken appears in the monitor. Use
to scroll though all the images saved on your xD-Picture
Card.
When you are finished reviewing your pictures:
• Press to turn the monitor off.
OR
• To return to the shooting mode, press the shutter button
halfway.
b. Erasing Pictures
Once erased, pictures cannot be restored.
The beauty of digital photography is your ability to keep
the photos you want, delete the rest, and reuse empty
memory space to take new pictures. This Digital camera
offers two ways to permanently erase unwanted digital
photos:
Single-Frame Erase: Deletes only the picture currently
displayed in the monitor.
• With the lens barrier closed, press and use the arrow
pad to display the picture you want to erase.
•Press .
• Press to select ERASE.
• Press to select YES, and then press .
Images can also be erased while in the “Quick View” mode
described in step 5a. This makes it easy to quickly erase a
picture that you just took.
All-Frame Erase: Deletes all pictures on the xD-Picture
Card in one operation, except for pictures you have
protected.
• With the lens barrier closed, press .
• Press , then press to select MODE MENU.
• Use to select the CARD tab, then press twice to
access the CARD SETUP screen.
• ALL ERASE should be highlighted. Press .
• As a safeguard, the Digital camera will ask you to select
YES or NO to confirm erasing, as this process permanently
deletes all unprotected pictures. Select YES and press .
TIP
TAKING PICTURES
There are two ways to compose your subject: using the
monitor or with the viewfinder. Depending upon the shooting
situation, there is advantages to each method. Please refer
to the printed Basic Manual for more information.
a. Taking a Picture with the Monitor
• Open the lens barrier fully.
• Decide the composition while looking at the image on the
monitor.
Icons representing camera settings appear on the
monitor, telling you important information such as the
Flash and record modes, battery life, and the number of
frames remaining.
• Press the shutter button halfway. The green lamp will light
steadily when the focus and exposure are set.
• Press the shutter button completely to take the picture. A
short beep confirms your picture has been taken.
b. Taking a Picture with the Viewfinder
• Open the lens barrier fully.
• Frame your subjects using the AF
target mark in the viewfinder.
• Press the shutter button halfway.
The Digital camera confirms the focus and exposure are
properly set when the green lamp in the viewfinder lights
steadily.The orange lamp lights up when it is
recommended to use the flash and/or when the flash is
recharging (when blinking) or ready to fire (when steady).
• Press the shutter button completely to take the picture.
A short beep confirms your picture has been taken.
c. Zooming
This Digital camera features a zoom lens, allowing you
to get closer to action, or capture wide-angle shots and
get everything into the picture.
• Push the zoom lever to zoom out and get everything into
the picture.
• Pull the zoom lever to choose telephoto shooting and get
closer to the action.
d. Flash Modes
This Digital camera features multiple flash modes.
Please note that not all flash modes are available
depending on the shooting mode selected.
With the shutter button depressed halfway, the flash is
ready to fire when the indicator in the monitor or the
orange lamp next to the viewfinder lights. When the
orange lamp is blinking, the flash is charging.
e. Number of Storable Pictures
Your digital camera can handle xD-Picture Cards from
16 MB to 512 MB. The number of storable pictures
depends on the image quality selected.
See the Reference Manual for complete descriptions of
each recording mode and the storable frame capacity for
that of xD-Picture Card.
To find out how many frames you have left, turn on the monitor
and look for the number in the lower right corner. Remember,
you can always delete unwanted pictures to make room for
more. (See Step 5.)

Orange lamp
Green lamp
Push to zoom out
Pull to zoom in
Icon Flash Mode Description
No
indication
Auto-flash The camera automatically decides if the flash is needed.
Red-eye
Reduction Flash
Reduces incidence of red-eye by emitting pre-flashes to
shrink pupil size before firing the main flash. The strobe
effect is normal operation for this mode.
Fill-in Flash The flash always fires with every picture.
Flash Off Turns the flash off for times when flash photography is
prohibited or not desired. The flash never fires.
TIP
INSTALLING THE CAMERA
SOFTWARE
You`ve now mastered the basic functionality of your new Olympus
Digital Camera! You are now ready to begin exploring the possibilities
that digital photography brings to your computer. Activities such as
photo editing, printing, and much more are only steps away!
About the Olympus CAMEDIA Master CD-ROM
Your Olympus Digital Camera comes bundled with a suite of software and documentation.
The CD includes:
• CAMEDIA Master: To download pictures from the camera, view, organize, retouch and print
your digital photos and movies.
• USB Driver for Windows 98: This utility must be installed to allow the camera to communicate
with your computer if it uses the Microsoft Windows 98 operating system.
• Olympus Digital Camera Reference Manual: A complete reference guide in digital form,
saved on the CD in PDF format.
You are now ready to install the computer software.
• Open the CAMEDIA Master CD-ROM package and locate the Software Installation Guide in
the language you wish to use.
• Continue to follow the step-by-step instructions for installing the software, and enjoy your new
digital photo processing capabilities!
CONNECTING THE CAMERA
TO A COMPUTER
Olympus recommends using the optional AC adapter to ensure a consistent
power supply when downloading images.
Make sure that the camera is turned off before connecting
it to your computer.
Windows 98 users must install the “USB Driver for
Windows 98” software before connecting the Digital
camera to the computer. Refer to the Software Installation
Guide for complete information.
TIP
Olympus makes it simple to connect the Digital camera to your
computer.
• Turn the camera off.
• Plug the supplied USB cable into the USB connector on your
camera and computer as illustrated on the right.
• The camera turns on automatically.
• The monitor turns on and the selection screen for the USB
connection is displayed.
• Press to select PC, and then press on the USB screen.
The camera starts communicating with the PC.
Additional Camera Features
This Digital camera offers a host of advanced features to expand your creativity. Here’s just a small sampling.
See the Basic Manual for details on these capabilities, and more!
• 7 Scene Program Shooting Modes: By using the on-line mode dial (virtual dial), you can easily select
the camera settings that most closely match your shooting situation.
• Sequential Shooting: Take a rapid succession of still pictures.
• Still Picture Editing: Edit still pictures and store them as new pictures.
• Macro Mode: For close-ups as tight as 0.7 ft. (0.2m), select Macro Mode.
• Movie Recording: Yes, this Digital camera records movies!
• Two-in-one Pictures: Combine two separate images taken in succession and store them as a single picture.
• Close-up Playback: Enlarge the pictures in the monitor to check details of the selected image.
• Index Display: View several thumbnail pictures on the monitor at once.
• Protecting Pictures: Prevents you from accidentally erasing photos.
• Video Playback: View your pictures and movies on a television monitor.
• Panorama Shooting: Connect overlapping images into a single picture using the panorama mode and
Olympus CAMEDIA Master software.
Remember to complete and return your Registration Card (not provided in some areas), and keep all camera
documentation handy.
Technical Support (USA)
1-888-553-4448 (Toll-free)
8:00 AM – 10:00 PM ET
Monday – Friday
European Technical Customer Support
00800 – 67 10 83 00 (Toll-free)
+49 180 5 – 67 10 83 or +49 40 – 237 73 899
(Charged)
9:00 AM – 6:00 PM MET
Monday – Friday
TIP
© 2004 OLYMPUS CORPORATION
qsge_pquick.fm 2 ページ 2003年12月15日 月曜日 午前10時37分

Leave a Comment